OpenSUSE install RVM

https://rvm.io/

gpg --keyserver hkp://keys.gnupg.net --recv-keys 409B6B1796C275462A1703113804BB82D39DC0E3 7D2BAF1CF37B13E2069D6956105BD0E739499BDB
\curl -sSL https://get.rvm.io | bash -s stable
rvm get head
rvm install ruby-2.5.0
 
Ruby header files: 
sudo zypper install ruby-devel

Kommentarer

Send en kommentar

Populære opslag fra denne blog

Hyundai i10 door panel removal

Billede
Here's a little guide to how to remove the door panels on Hyundai i10. My goal was to see how I could replace the stock speakers in the car. This will be in another post when I get to it. There are two screws in the door which have to be removed. There's a little cover which easily pops open. In order to proceed you are gonna need a set of tools like this: When the screws removed, start by removing the panel near the rear mirror joystick. Use the tools above: Then you are gonna remove the window crank. I used the same tools as above to get underneath the crank, and then with some force pulled it off. Then start removal of the whole panel by starting at the bottom. There's a small gap between the panel and the door located at the bottom, which is an easy starting point. When you get around the whole panel, it should snap right off. My car had no wires attached to the panel at all. The following is pictures of the panel and speakers, which I
Læs mere

Hyundai i10 Subwoofer installation

Billede
This is the first time that I've upgraded any part of a car, so this post is more or less about what I learned and how I did it. I wanted more bass in my car and I definitely got it. Most of theese images are work in progress btw. I acquired the following items that I wanted to install: Blaupunkt GTB 1200 subwoofer 250 RMSW - 850W Max Pioneer GM-D8601 Amplifier 500W Continuous Power Output - 1600W Max  Pioneer 2DIN headunit - MVH-AV290BT USB/AUX/BT I started off by essentially just unscrewing stuff to see what was possible. I spend a lot of time just removing panels everywhere in the car to uncover where I could wire it all up. At the end I ended up with something like this:  1. I connected a powerwire to battery with a 40 amp fuse installed. I bought all the cables as a set similar to the picture. This included RCA-cables, power wire, ground wire, fuseholder with fuse and some connectors.  2. The power wire is pull through the so called firewall w
Læs mere